Setting the Coordinates

To change the default coordinates in Fusion 360, go through these steps:
1. Click on your name near the top right corner of the Fusion 360 working screen
2. Look in the preferences where it says “Y-up”. It is number 6 under “Controlling general UI behaviour”.
This means the coordinate y is going vertically upwards.
3. Click on it, you will see that there are two options: Select “Z-up”
4. Accept the result.
5. Enjoy the bliss of 3D parametric modeling.
OA Fakinlede

7 comments on “Setting the Coordinates

  1. SUNDAY, Ernest Eromosele (13BE002725) says:

    Thank you sir.

  2. Ayinde oluwafemi says:

    Thank your Sir

  3. Ogunfowora Oluwaseyi says:

    Thank you sir.

  4. Ajibade Pipeoluwa says:

    Thank you sir

  5. USIFOH Benedict says:

    Thank you very much sir…

  6. Hermans-Efenudu.Joshua says:

    thank your sir, we appreciate.

Leave a Reply to Hermans-Efenudu.Joshua Cancel reply

Your email address will not be published. Required fields are marked *